Beskrivelse
This product is a SX1276 chip based on ESP32 WIFI increased OLED, namely LoRa remote modem, 868MHz frequency, high sensitivity is over-148dBm, + 20dBm output power, high reliability, long transmission distance.
The 868MHz antenna needs to be in connection with the IPEX interface (if the antenna is not connected, the signal reception will be unstable)
Lithium battery charge and discharge circuit, when the battery is full, the blue LED will stop working. When using, pay attention to the positive and negative of the battery, otherwise it will be daed!
With IO port Press sn Press signal input, you need to add the 100nF pull-down capacitor to this pin.
the onboard 4Mt bytes (32 Mt bit) wi-fi antenna,lithium battery charging circuit, CP2102 interface and USB serial chip, the perfect support for Arduino development environment, can be used for program checking and product development is very easy and fast.
Operating voltage: 3.3V to 7V
Operating temperature range: -40 Celsius to + 90 Celsius
Support for Sniffer software protocol analysis, Station, SoftAP, and Wi-Fi Direct modes
Data rates: 150 Mbps @ 11n HT40., 72 Mbps @ 11n HT20, 54 Mbps @ 11g, 11 Mbps @ 11b
transmit power: 19.5 dBm @ 11b, 16.5 dBm @ 11g, 15.5 dBm @ 11n
receiver sensitivity up to -98 dBm
UDP sustained throughput of 135 Mbps
colour:black
Material:Metal + plastic
size:oled display: 0.96 inch
Package Contents:
2*Bluetooth WIFI module
Note:This product does not include the battery.
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
Anonym (bekreftet eier) –
Varene funker som de skal, kunne godt hatt link på nettsiden til instruksjoner om hva slags library som brukes